Design and Manufacture 2 ENG2015
- Academic Session: 2019-20
- School: School of Engineering
- Credits: 10
- Level: Level 2 (SCQF level 8)
- Typically Offered: Semester 2
- Available to Visiting Students: Yes
- Available to Erasmus Students: Yes
This course develops the topics of design and manufacturing including: concurrent engineering; interchangeability; limits and fits; materials selection theory and introduction to CES; costing; design for casting; design for sheet metal forming; design for injection moulding; heat treatments for metals; inspection and quality control.
2 lectures per week
Requirements of Entry
Mandatory Entry Requirements
Recommended Entry Requirements
70% Written Exam
30% Set Exercise: Moodle quizzes
Main Assessment In: December
The aim of this course is to further develop the students' knowledge and understanding of engineering application, practice and the manufacture and their relation to engineering design.
Intended Learning Outcomes of Course
By the end of this course students will be able to:
■ describe basic engineering components, materials and manufacturing processes;
■ discuss the interaction between manufacturing process and design and cost of components;
■ produce engineering drawings to recognised engineering standards;
■ use materials selectin theory and the associated CES software;
■ describe applications and limitations of inspection techniques.
Minimum Requirement for Award of Credits
Students must attend the degree examination (worth 70% of the final mark)
Students must attend the timetabled laboratory classes.
Students must attempt a minimum of 8 of the 10 Moodle quizzes on the course (worth 30% of the final mark).
Students should attend at least 75% of the timetabled classes of the course.
Note that these are minimum requirements: good students will achieve far higher participation/submission rates. Any student who misses an assessment or a significant number of classes because of illness or other good cause should report this by completing a MyCampus absence report.